Sharp AH-A12BE - BASIC OPERATING PROCEDURES; SELECTING THE OPERATING MODE; ADJUSTING THE DESIRED TEMPERATURE; ADJUSTING THE FAN SPEED

Press the THERMO. button to set the
desired temperature.
AUTO/DRY MODE
The temperature can
be changed in 1°C in-
crements within the
range of 2°C higher to
2°C lower from the tem-
perature automatically
determined by the air
conditioner.
COOL(HEAT for AY-A07BE/AY-A09BE/AY-A12BE)MODE
The temperature can
be set within the range
of 18 to 32°C.
1
E-8
BASIC OPERATION
2
Press the ON/OFF button to start op-
eration.
• The red OPERATION lamp ( ) on the
unit will light.
3
4
1
4
5
2
3
(
HEAT
is only for AY-A07BE/AY-A09BE/AY-A12BE)
Press the MODE button to select the
operation mode.
AUTO HEAT COOL DRY
5
MODE
DISPLAY MODE
FAN1H
SWING
CANCEL
TEMP.
TEMP.
FAN TIMER
Please the FAN button to set the de-
sired fan speed.
AUTO SOFT LOW HIGH
• In the DRY mode, the fan speed is pre-
set to AUTO and cannot be changed.
To turn off the unit, press the ON/OFF
button again.
• The red OPERATION lamp ( ) on the
unit will turn off.