1
Press the MODE button to select the
operation mode.
AUTO COOL DRY
2
Press the ON / OFF button to start opera-
tion.
The red OPERATION lamp ( ) will light up.
TO TURN OFF
Press the ON / OFF button again.
The red OPERATION lamp ( ) will turn off.
3
Press the THERMOSTAT button to set
the desired temperature.
(AUTO / DRY mode)
The temperature can
be changed up to ±2°C
from the automatic
setting.
(COOL mode)
The temperature setting
range: 16-30°C.
4
Press the FAN button to set the desired
fan speed.
BASIC OPERATION
AUTO SOFT LOW HIGH
NOTE:
AUTO MODE
In the AUTO mode, the temperature setting and
mode are automatically selected according to the
room temperature when the unit is turned on.
DRY MODE
The fan speed is preset to AUTO and cannot be
changed.
WHEN POWER FAILURE OCCURES
This air conditioner has a memory function to store
setting when a power failure occurs.
After power recovery, the unit will automatically re-
start in the same settings which were active before
the power failure, except for TIMER, POWERFUL
JET / SUPER JET, COMFORT, BABY MODE, SELF
CLEAN settings.
OPERATION CONDITION
Mode
Indoor
Temp.
Outdoor
Temp.
Cooling
Upper limit 32°C 43°C
Lower limit 21°C 21°C
The build-in safety device may prevent
the unit from operating when used out of
this range.
Condensation may form on the air outlet
if the unit operates continuously in the
COOL or DRY mode when humidity is
over 80%.
1
4
3
2
AH-AP9SMD&ED_OM_A908_En.indd 52015/3/24 16:54:17
To Next Page
Loading...
