obliquely upward to deliver cool air
to the ceiling in order to avoid direct
1
During operation, press the GENTLE
COOL AIR button.
The remote control will display .
TO CANCEL
Press the GENTLE COOL AIR button
again.
NOTE:
If you want GENTLE COOL AIR operation
in POWERFUL JET / SUPER JET mode,
press GENTLE COOL AIR button during
POWERFUL JET / SUPER JET operation.
GENTLE COOL AIR
1
NOTE:
Use of the PLASMACLUSTER operation will
be memorized, and it will be activated the next
time you turn on the unit.
To perform PLASMACLUSTER operation in
FAN only mode, press the PLASMACLUSTER
button when the unit is not operating.
The mode symbol of the remote control will
go off and the fan speed cannot be set to
AUTO.
(For SMD models only)
Plasmacluster ions released into the room
will reduce some airborne mold.
1
During operation, press the PLAS-
MACLUSTER button.
The remote control will display .
The blue PLASMACLUSTER lamp ( )
will light up.
TO CANCEL
Press the PLASMACLUSTER button again.
The blue PLASMACLUSTER lamp ( )
will turn off.
PLASMACLUSTER OPERATION
1
AH-AP9SMD&ED_OM_A908_En.indd 72015/3/24 16:54:18
To Next Page
Loading...
