Name: Sharp AN-SS1
Brand: Sharp
Rating: 5 (1 reviews)

To Next Page

To Previous Page

EN-10

This unit can easily be paired / connected with the help of voice prompts.

If voice prompt says that the battery is insufcient, then you are advised

to recharge the battery before proceeding to pair and connect.

In case pairing is not completed within three minutes for various reasons,

the power automatically turns off, with power switch still in ON position.

To turn the device on, slide the Power Switch to OFF position and then

back to ON position.

Quick Connection

1 Turn on the unit by sliding the power switch towards the ON position.

The unit switches to Search Mode and the Blue LED turns on.

2 Perform pairing procedure on the source device to detect this unit.

“AN-SS1 SHARP” will appear in the detected devices list (if available)

in the source device. (Refer to the source device operating manual

for details).

Notes:

z Place the devices to be paired within 1 meter (3 feet) of each other

when pairing.

z Some source devices are unable to display lists of detected devices.

To pair this unit with the source device, refer to the source device

operating manual for details.

3 Select “AN-SS1 SHARP” from the source list. If Passcode* is required,

enter “0000”. When connection is complete, it is announced by voice

prompt.

* Passcode may be called PIN Code, Passkey, PIN number or Password.

Listening to Bluetooth enabled devices (continued)

Questions and Answers:

Need help?

Do you have a question about the Sharp AN-SS1 and is the answer not in the manual?

Sharp AN-SS1 Specifications

General