-
7
-
8
Viewing E-Manual
Viewing the Built-in Operation Manual
Press
e-manual
on the remote control unit to display
operation information on the screen.
To search for an item from the table of contents, and to
search for a particular term and to fi nd troubleshooting
information, press
e-manual
while watching the TV and
then select the applicable item from the manual cover
page that appears.
1 Press e-manual while watching the TV.
This displays the built-in operation manual screen.
2 When you select contents, its page will be displayed.
2
1
TV
Appendix
Troubleshooting
The problems described below are not always caused by malfunctions. Check the TV again before having the TV serviced.
Problem Possible Solution
•
No power.
•
Check if you pressed
POWER
on the remote control unit.
•
Is the AC cord disconnected?
•
Has the power been turned on?
•
Remote control unit does
not operate.
•
Are batteries inserted with polarity (+, –) aligned?
•
No picture.
•
Is connection to other components correct?
•
No sound.
•
Is connection to other components correct?
CLEARING THE PASSWORD
If you forget the password, clear the password using the following procedure.
1 From the HOME screen, select “Settings” > “Security & Restrictions” > “Parental Control” > “Password”, and then
press
(ENTER) and the password input screen will display.
2 Enter “3001” using 0 – 9, select “Disable” in the password settings, and then select “Enable” to reset password.
3 Select “Back to settings”.
4 Select “Password” then select “Enable” to set password for parental control.
5 Enter the 4-digit number as a password using 0 – 9, and then enter the same 4-digit to confi rm. The new password
is now set.
Symbols placed on equipment
• This mark indicates the product operates on AC Voltage.
• This mark indicates a class II or double insulated electrical appliance wherein the product does not require a safety
connection to electrical earth (ground).
Initial installation
Follow the steps below one by one when using the TV for the fi rst time. Some steps may not be necessary depending on
your TV installation and connection.
Connect an antenna cable to the antenna terminal.
or
Plug the AC cord into the AC outlet.
4T-C60AL1X
Cable tie
Bundle the
cables into cable
tie.
Press cable tie
clip (
1
) and pull
out cable tie (
2
)
completely to
release.
• Place the TV close to the AC outlet, and keep the power
plug within reach.
• Product shape varies in some countries.
For the Philippines only
Antenna adaptor (supplied)
or
Press (JOG-KEY) on the TV.
4T-C60AL1X
Run the initial installation.
• Follow the guide on the TV screen to set the following
settings.
Language setting
Country setting
Channel setting
Home/Store setting
Pairing setting
Initial setup has fi nished
Initial setup guide 4T-C60AL1X_C70AL1X_H184.indb 4Initial setup guide 4T-C60AL1X_C70AL1X_H184.indb 4 11/7/2018 3:13:01 PM11/7/2018 3:13:01 PM
To Next Page
Loading...
Need help?
General