14
Setup menu
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1 Press MENU and the MENU screen displays.
2 Press c/d to select “Setup”.
3 Press a/b to select “Auto Installation”, and then
press OK.
If you have already set the PIN under “Child Lock”,
enter it here.
• See page 16 for setting PIN.
4 Press c/d to select “Ye s ”, and then press OK.
5 You can set language and country the same as in
the initial auto installation. Follow steps 1 and 2
on page 7.
Programme Setup
This section describes how to set up analogue TV
channels manually.
Menu operations
MENU
[
Setup
]
Setup Option
Child Lock
Auto Installation
Programme Setup
Position
WSS
4:3 Mode [Panorama]
[On]
[English]
[Normal]
Language
Rotate
Auto Search
You can automatically search for and download TV
channels by performing the procedure below. This is
the same function as from programme auto search to
preset download in Auto Installation.
1 Repeat steps 1 to 4 in Programme Setup.
2 Press c/d to select “Ye s ”, and then press OK.
1 Programme auto search
2 Auto labelling
3 Auto sorting
4 Preset download
1 Press MENU and the MENU screen displays.
2 Press c/d to select “Setup”.
3 Press a/b to select “Programme Setup”, and
then press OK.
If you have already set the PIN under “Child Lock”,
enter it here.
• See page 16 for setting PIN.
4 Press a/b to select “Auto Search”, “Manual
Adjust”, “Sort” or “Erase Programme”, and then
press OK.
Auto Search
Manual Adjust
Sort
Erase Programme
No Yes
Power Control menu
No Signal Off
Menu Operation: A (page 11)
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
• Five minutes before the power shuts down, remaining time
displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
MENU
[
Power Control
]
Audio Power Control
No Signal Off
No Operation Off
[Disable]
[Disable]
No Operation Off
Menu Operation: A (page 11)
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
• Five minutes before the power shuts down, remaining time
displays every minute.
Power Management
Menu Operation: A (page 11)
When set, the power will automatically shut down.
Off: • No power management
• Factory preset value.
Mode1: • If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off.
• The TV turns on again by pressing a on the
TV or B on the remote control unit. (See page
7.)
Mode2: • If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing a on the
TV or B on the remote control unit. (See page
7.)
TV/AV only
TV/AV only
TV only
TV only
PC only
Item
To Next Page
Loading...
