3
Quick guide
Attaching the stand
Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
1 Confirm the 8 screws supplied with the TV.
Short screws (m4)
(used in step 2)
Long screws (m4)
(used in step 4)
2 Attach the two parts of the stand unit to each other
using the 4 short screws as shown.
3 Insert the stand into the opening on the bottom of
the TV.
4 Insert and tighten the 4 long screws on the rear
of the TV as shown.
NOTE
• To detach the stand, perform the above steps in reverse order.
Before performing work spread cushioning over the base area to lay the TV on, making sure the
area is completely flat. This will prevent it from being damaged.
Setting the TV
Standard DIN45325
plug (IEC 169-2)
75-ohm coaxial cable
Setting the TV on the wall
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.
Ferrite Core
The Ferrite Core should be permanently attached
and never removed from the AC cord.
AC cord
Product shape
varies in some
countries.
Place the TV close to the
AC outlet, and keep the
power plug within reach.
Ferrite Core
Cable clamp
Cable tie
LC-32GA8E_GB_a 06.4.28, 10:19 AM3
To Next Page
Loading...
