3 4
Antenna connection
Connect antenna cable to the antenna terminal
If your outdoor antenna uses a 75-ohm coaxial
cable with a standard DIN45325 plug (IEC
169-2), plug it into the antenna jack at the rear of
the set.
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH
THE AC CORD CONNECTED.
NOTE
• Place the TV close to the AC outlet, and keep the power plug within reach.
Trademarks
• The terms HDMI and HDMI High-Defi nition Multimedia Interface, and the HDMI Logo are trademarks or registered
trademarks of HDMI Licensing, LLC in the United States and other countries.
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work, spread cushioning over the base area to lay the TV on. This will prevent it from
being damaged.
1
Confi rm the screws supplied with the TV.
Screws (
4)
2
Insert the stand assembly into the openings on the bottom of the TV. (
1
)
3
Insert and tighten the screws into the holes on the rear of the TV. (
2
)
1
2
Soft cushion
Stand base with letter “L”
Stand base with letter “R”
NOTE
• To detach the stand, perform the steps in reverse order.
CAUTION
• Do not attach or detach the stand without holding it.
Doing so can cause the stand to fall, resulting in serious personal injuries as well as damage to the stand.
LC-32LE180M_G591_EN.indd 2LC-32LE180M_G591_EN.indd 2 3/9/2016 8:32:54 AM3/9/2016 8:32:54 AM
To Next Page
Loading...
