Sharp Aquos LC-80UE30U

Video In (Continue)
Audio Select
This function sets the terminal to output the
computer audio.
The adjustment items vary depending on
the input source. Select the input source
corresponding to the terminal connected to
the PC and then adjust the desired item.
To perform the operation, refer to "Devices"
> "Video in" > "HDMI 3" > "Audio Select".
HDMI 3
HDMI(Digital): Select this when the TV and
PC are connected using an HDMI-
certified cable and audio is input via the
same cable.
HDMI+Analog: Select this when the TV and
PC are connected using a HDMI-certified
cable and the audio is input via a Ø 3.5
mm stereo minijack.
NOTE
When "Audio Select" is set to
"HDMI+Analog", sound will not be
produced if you use only an HDMI-
certified cable to connect HDMI-
compatible equipment. To produce
sound, you should make an analog audio
connection.
If you want to connect HDMI-compatible
equipment using only an HDMI-certified
cable, set "Audio Select" to
"HDMI(Digital)".
"Audio Select" can only be set for the
HDMI IN 3.
Devices Operation
ENG42
ENGLISH | FRANÇAIS | ESPAÑOL
>><<