Antenna & Cable/STB
Select the type of connection you will use to watch TV.
6 Press _ to select "Antenna & Cable" or "Set-top box",
and then press ENTER.
_To watch TV, select the input source corresponding to
the terminal connected to the set-top box. When doing
so, you must make the setting to skip "TV". Press _1_/_to
select "On", and then press ENTER.
To watch TV via an antenna or cable connection
(without using a set-top box):
Select "Antenna & Cable", and then go to step 7.
To watch TV via a set-top box:
_Select "Set-top box", and then press ENTER.
_Check that the set-top box connected to the TV is on.
_Press _ to select the input to which the set-top box
has been connected.
• If your Set-top box is turned off, "Disconnected" might be
shown.
• When this is set to "On", the channel on the TV cannot
be changed using the remote control unit or menu. (e.g.
CH Z%J_M_,Favorite CH, etc.)
• See Dace 4-20 for details on the Input Skip function.
_Press INPUT to select the input source corresponding to
the terminal connected to the set-top box. Make the
necessary settings on the connected external equipment.
• See the operation manual of the connected equipment for
setting up the equipment.
Air/Cable (Antenna setting)
Make sure what kind of connection is made with your TV
when selecting "Air" or "Cable".
7 Press _to select "Air" or "Cable".
Press ENTER to enter the setting.
ENG 2-4
To Next Page
Loading...
