EasyManua.ls Logo

Sharp AQUOS wish4 - Page 27

Sharp AQUOS wish4
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 26 -
Do not cover the light sensor with your finger or put a sticker on it.
Doing so may hinder the light sensor from detecting the ambient
brightness and functioning correctly.
Do not put a sticker, etc. on the proximity sensor. Doing so may cause
the sensor to malfunction and make the display always turned off
while making a call or during a call.
Covering earpiece (receiver), mouthpiece (microphone), speaker,
sub microphone and air vent port section (decoration of camera
cover) with stickers or fingers may hinder product performance.
If you hold the earpiece (receiver) to your ear over your hair to talk,
the proximity sensor may malfunction. This may cause the display to
remain on, allowing the call to be disrupted if the display is
accidentally touched.
Putting a sticker, etc. on the display or a key may cause malfunction
or shortened usage time. Also, doing so may damage the product.
If you put magnetized objects close to the product, the speaker
section sometimes emits sounds. This is not a fault.
Note that if you forcefully pull the SIM card/microSD memory card
tray or apply excessive force on it, it may be damaged.
Bright places such as under the direct sunlight sometimes make it
hard to see the display. This is not a fault.
Use the product with the SIM card/microSD memory card tray closed.
If the card tray is open, dirt or water may get inside causing a fault.
Do not allow liquids, metal objects, and other foreign matter to get
inside the SIM card/microSD memory card tray slot of the product.
Doing so might cause a fault.

Related product manuals