12
Charging with ROBOQUL
Charge using ROBOQUL [SHEGH1] and an AC Adaptor (USB
Type-C™ quick charge AC Adaptor for USB PD [ZSDBAS] (SB-
AC20-TCPD)) (optional accessories).
When charging using ROBOQUL and handset is powered on,
ROBOQUL swivels when Display lights up, at start of charging,
for incoming calls, alarms, etc. See "Using ROBOQUL" for
details on setting ROBOQUL motion.
Use ROBOQUL on a flat and stable surface.
Handset does not quick-charge when using ROBOQUL. See
"Handset" for charge times with an AC Adaptor/ROBOQUL.
Insert USB Type-C plug on AC Adaptor into ROBOQUL power
connection terminal
Raise plug on AC Adaptor and plug into outlet
Insert ROBOQUL charging plug into External Connection Jack
( ), and lean handset backward ( )
Charging/Notification Lamp illuminates once charging
starts.
・Press handset firmly and straight all the way. If not
attached adequately, handset may fall or ROBOQUL may tip
over. Avoid scratching handset when attaching.
・
To continue using ROBOQUL after charging, skip and
.
After charging, remove handset from ROBOQUL and disconnect
USB Type-C plug on AC Adaptor
・Hold down ROBOQUL while pulling handset straight up.
Unplug AC Adaptor and lower plug
Charging ends.
Using ROBOQUL Functions
You must set permissions for ROBOQUL to use functions
beforehand. See "Before Using ROBOQUL" for details.
To Next Page
Loading...
Need help?
General
