Sharp AR-M256 - REPLACING THE TONER CARTRIDGE

71
TROUBLESHOOTING AND MAINTENANCE
5
MISFEED IN THE UPPER EXIT AREA
( when a job separator tray kit or finisher (AR-FN5A) is installed )
If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area.
1
Open the upper right side cover.
2
Gently pull the misfed paper out.
Be careful not to tear the
misfed paper during
removal.
3
Close the upper right side cover.
Make sure that the misfeed message is cleared.
MISFEED IN AN OUTPUT TRAY
(when a finisher (AR-FN5A) is installed)
1
Grasp the handle of the stapler
compiler cover and pull to open the
cover.
2
Remove any misfed paper from the
transport area.
A MISFEED HAS OCCURRED.
INFORMATION
ar_m318_uk_cpy.book 71 ページ ２００７年１月１５日 月曜日 午前１１時３６分