Sharp AU-X08CR - Disassembling Procedure

AH/AY-X08CR
AH/AY-X10CR
AH/AY-X13CR
DISASSEMBLING PROCEDURE
FOR INDOOR UNIT [AY-X08BCR/X10CR/X13CR AND AH-X08CR/X10CR/X13CR]
CAUTION : DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE ANY SERVICING
6. Remove the unit-to-unit wiring from the terminal
board.
3. Remove the screw fixing the cord clamp. 7. Remove a screw fixing the control box cover, and
Note: During reassembly, install the holder after remove it.
installing the front panel. This will make it
easier to assemble the front panel.
8. Remove a screw fixing the ground wire.
4. Close the open panel. Pushing the nail of the front Note: During reassembly, take care for the
panel. direction of the lead wire.
34