Sharp AU-X08CR - Page 36

AH/AY-X08CR
AH/AY-X10CR
AH/AY-X13CR
17. Remove the drain cover from the evaporator.
Note: During reassembly, verify that the dew on
the pipe is led to the drain pan.
20. Remove 2 screws fixing the motor cover, and pull up
the fan.
21. Loose a screw fixing fan.
[Cautionary points for assembling the fan]
a. When inserting the motor shaft into the metal fan
boss, take care to prevent injuring the inner surface of
the metal fan boss.
b. Before fastening the motor shaft and fan, insert the
motor shaft into contact with the bottom of the metal
fan boss.
Cross flow fan Fan motor
19. Remove the evaporator from the cabinet.
Motor shaft
36