Sharp AY-X099E User Manual

38
AH-X079E/X099E
AY-X079E/X099E
13. Remove the compressor cover.
14. Remove the thermostat of the heat exchanger.
[AE-X079E/AE-X099E]
[AU-X079E/AE-X099E]
16. Cautions when replacing the Power Factor Module,
Power Transistor Module, or Diode Bridge
(1) The screws should be firmly tightened at the
torque of 8 to 10 kg f cm (78.4 to 98 N).
(2) For the Power Transistor Module or Diode
Bridge, be sure to insert the silicon sheet
between it and radiator plate.
(3) For the Power Factor Module, the silicon grease
should be evenly applied between it and radiator
plate.
15. Remove the front panel assembly.
Orifice 2 screws 4 hooks
Control cover 4 screws
Wire guard 4 screws
Remove these screws and disengage these hooks.
Heat exchange 
pipe thermistor
Heat exchange pipe thermistor
fixed position
Heat exchange 
pipe thermistor
Heat exchange pipe thermistor
fixed position
Joint tube
4 hook
4 screws
2 screws

Sharp AY-X099E Specifications

General

Brand	Sharp
Model	AY-X099E
Category	Air Conditioner
Language	English