Sharp CD-PC651H

RADIO OPERATION
(Main unit operation)
MB Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the desired fre-
quency band. (FM ST, FM or AM)
4 Press the TUNING/TIME (\v or A) button to tune into the
desired station.
Manual tuning:
Press the TUNING/TIME (\v or A} button as many limes as
required to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING/TIME (vv or A) button is pressed for more
than 0.5 seconds, scanning will start automatically and the tuner
will stop at ihe first receivable broadcast siation.
Notes:
@ When radio interference occurs during auto scan tuning, auto
scan tuning may stop automaticaily at that point.
@ |f a weak station signal is found during auto scan tuning, the
station will be skipped.
@ To stop the auto tuning, press the TUNING/TIME (v or A)
button again.
@ When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator
will light, Finally, the station name will appear.
5 To receive an FM stereo transmission, press the TUNER
(BAND) button so that the "ST" indicator on the display lights
up.
"op" will appear when an FM broadcast is in stereo.
lf the FM reception is weak, press the TUNER (BAND) bution
so that the "ST" indicator goes out.
@ The recepiion changes to monaural, the sound becomes
clearer.
q @
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Note:
@ The last station tuned in will be recalled, even after changing
the tuning band or the function, or after switching the unit to
the stand-by mode.
E-16