Sharp CD-PC651H

(Main unit operation)
ROS PTY
EON TA
RCS PTY
EQU] \ TP
Mi EON-PTY
1 Tune in the desired RDS station (when a station name is
being displayed).
2 Press the EON button when "EON" appears.
@ "PTY Tl" and "SELECT" will appear alternately for about 6
seconds.
3 Whilst they are being displayed, select the desired programme
type using the PRESET (v or A) buiton.
The selected programme type will flash.
®
4 Within 4 seconds, press the PTY.T| SEARCH button,
®
The selected programme type and "WAITING" will be dis-
played for 2 seconds each.
@ 'PTY" will appear, and the unit will enter the EON-PTY stand-
by mode.
5 When a programme of ihe type specified stars on an ON
(other network} station, the unit will automatically switch to the
station broadcasting the selected programme type, and "PTY"
will flash.
6 When the programme specified for the ON station is over, the
unit will automatically reiurn to the original station you were
tuned to.
Note:
@ Ii the EON button is pressed when "EON" is not displayed,
"NO EON" will appear for 5 seconds to indicate that the unit
cannot enter the EON stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button.
("Programme type" — "WAITING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within
4 seconds, press it again. The EON stand-by mode will be can-
celled.
@ “PTY” will go out.
About the PTY! (Dynamic PTY Indicator):
PTYI| (Dynamic PTY Indicator) will appear whilst the Dynamic
PTY station is being received.
Dynamic PTY indicates that the PTY for the station tuned in, or
the PTY referenced in the EON data, is assessed whenever the
programme changes and may be changed.
PTY “Meaning
Lights up Tuned into a dynamic PTY station.
~ Goes out. | Tuned intoastalic PTY.
Note:
@ When "PTYi" appears, if you press the DISPLAY MODE but-
ton to display the programme type, you can check the type
of programme you are actually receiving.
E-24