Sharp CP-SW1000H Quick Start Guide

Locking tab
Back of remote control
TINSEA210AWZZ
07H R AS 1
This Quick Start Guide will help you to correctly install and operate your system.
MODEL
CP-SW1000H
SUBWOOFER SYSTEM
Accessories
RCA cable
(2 pins - 2 pins) x 1
AC power lead x 1
Spike x 4
Before using remote control
Before using remote control, please remove plastic shield
at battery holder.
Remote control battery installation
1 Whilst pushing the locking tab towards the centre of
the remote control, slide out the battery holder.
2 Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Use the “CR 2025”, coin lithium battery.
Turn on your system
1 Press the ON/STAND-BY button to turn the power on.
The volume indicator lights up blue.
2 To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
The STAND-BY indicator lights up red.
Battery holder
Locking tab
Positive (+)
side up
Polarity (+)
symbol
Battery type
Battery holder
Plastic shield
Remote control
Remote control x 1
Cleaning cloth x 1
Subwoofer
stand x 2
Foot cushion x 4
(Lights
up blue)
(Turns red)
RCA cable
(1 pin - 2 pins) x 1
CP-SW1000H QG 9/7/07, 3:15 PM1

Sharp CP-SW1000H Specifications

General

Enclosure Type	Bass Reflex
Driver Size	10 inches
Inputs	Speaker Level Input
Outputs	Speaker-level
Crossover Frequency	50Hz - 150Hz
Phase Switch	0/180 degrees