Locking tab

Back of remote control

TINSEA210AWZZ

07H R AS 1

This Quick Start Guide will help you to correctly install and operate your system.

MODEL

CP-SW1000H

SUBWOOFER SYSTEM

Accessories

RCA cable

(2 pins - 2 pins) x 1

AC power lead x 1

Spike x 4

Before using remote control

Before using remote control, please remove plastic shield

at battery holder.

Remote control battery installation

1 Whilst pushing the locking tab towards the centre of

the remote control, slide out the battery holder.

2 Remove the old battery from the battery holder, insert

the new battery and then slide the battery holder back

into the remote control.

Use the “CR 2025”, coin lithium battery.

Turn on your system

1 Press the ON/STAND-BY button to turn the power on.

The volume indicator lights up blue.

2 To set the unit to stand-by mode:

Press the ON/STAND-BY button again.

The STAND-BY indicator lights up red.

Battery holder

Locking tab

Positive (+)

side up

Polarity (+)

symbol

Battery type

Battery holder

Plastic shield

Remote control

Remote control x 1

Cleaning cloth x 1

Subwoofer

stand x 2

Foot cushion x 4

(Lights

up blue)

(Turns red)

RCA cable

(1 pin - 2 pins) x 1

CP-SW1000H QG 9/7/07, 3:15 PM1

Sharp CP-SW1000H - Page 22

Table of Contents

Other manuals for Sharp CP-SW1000H

Related product manuals