E-24
0.5h 1.0h 1.5h 10h 11h 12h
NOTES ON TIMER SETTING AND OPERATION
• The latest time setting will be memorized and will appear on the remote control display the next
time you set the OFF TIMER or ON TIMER.
• The OFF TIMER, ON TIMER and SLEEP operation can not be set together.
Only the most recent settings will be used.
• If a power failure occurs while the OFF TIMER or ON TIMER is set, the TIMER setting will be can-
celled and will not be retrieved even after the power is restored.
The unit will turn off automatically according to your setting.
Timer duration can be set from a minimum of half an hour (30 minutes) to a maxi-
mum of 12 hours.
Up to 9.5 hours, you can set in half-hour (30-minutes) increments and from 10 to
12 hours, in 1-hour increments.
OFF TIMER
1
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the OFF TIMER button and set the
time as desired.
• The time setting will change as you press the but-
ton as follows.
Hold the button down to speed through the set-
tings.
• The orange TIMER lamp on the unit will light.
• The unit will emit a beep when it receives the sig-
nal.
• The time setting will count down to show the re-
maining time.
TO CANCEL TIMER
Press the CANCEL button.
• The orange TIMER lamp on the unit will turn off.
Display shown when you
set the unit to turn off 2.5
hours later.
TIMER OPERATION
To Next Page
Loading...
Need help?
General
