Sharp DK-CL5P - Alarm and Sleep Operation

22
2010 November 3
DK-CL5P_A6 02-27.fm
DK-CL5P
Radio/Advanced Features
Listening to the radio (continued)
Note:
The batteries system protects the programmed stations should
there be a power failure or the AC/DC adaptor becomes
disconnected. If the backup batteries are drain off, the
programmed stations will be erased.
■ To recall a programmed station
Alarm and sleep operation
■ Alarm
The unit turns on and play desired source (iPod, iPhone or
TUNER) or Buzzer sound for 1 hour alarm cycle.
Before setting the alarm:
Setting the alarms
In this example, the setting is for ALARM 1. The same method
is used to set for ALARM 2.
Press PRESET/TRACK ( or ) button on main unit
repeatedly or PRESET/FOLDER ( s or r ) on remote control
repeadtedly to select the desired programmed station.
1 Check that the clock is set to the correct time. (refer page 15)
If it is not set, you cannot use the alarm function.
2 For iPod or iPhone playback: Insert iPod or iPhone to the
unit. (refer page 17)
3 For TUNER: Set preset memory. (refer page 21)
1 In standby mode, press and hold the ALARM 1 button
until the alarm time blinking.
2 Press the ( or ) button to adjust the hour and
press the ALARM 1 button.
Press the ( or ) button once to advance the time by 1
hour. Hold it down to advance continuously. “AM” or “PM”
indicator will interchange after each 12 hour cyclic.
PM