Sharp DV-NC65H - Page 16

16
DV-NC65H/S
DV-NC70H
6) Removing the cassette housing control/ the VCR mechanism.
(1) Remove the two screws u.
(2) Remove the two screws i.
(3) Remove the one screw o.
13
14
16
15
17
18
19
21
20
23
22
24
(6) Remove the two screws e to remove the power PWB unit.
7) Removing the rear panel/ the antenna terminal cover/
the VCR main PWB unit.
(1) Remove the five screws p at rear side.
(four screws in DV-NC65H/S)
(2) Remove the one screw a for Tuner.
(3) Remove the rear panel.
(4) Remove the two screws s.
5) Removing the rear PWB unit.
(1) Remove the two screws r (for 21 pin) at rear side.
(2) Remove the five screws t to remove the rear PWB unit
and the earth plate.
(3) Remove the five connectors of the FFCs.
(4) Remove the rear PWB unit.
(5) Remove the four screws y to remove the rear PWB
holder.
(5) Remove the antenna terminal cover.
(6) Remove the one screw d.
(7) Remove the VCR main PWB unit.
8) Removing the bottom plate.
(1) Remove the one screw f.