EasyManua.ls Logo

Sharp DW-D20A - Before Use

Sharp DW-D20A
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Do not use in the following places
dž
0
5
10
20
40
BEFORE USE
WHEN USING FOR THE FIRST TIME
INSTALLATION LOCATION
1
2
Avoid places with direct sunlight.
Level, stable place
There might be some water left in the water tank from the factory product inspection. This
is not a malfunction.
Packaging
material
Take out the product
from the box
Always hold the knob and take
out from the box.
Keep the box and packaging
materials for future product
storage.
Place it on a level,
stable place and
insert the power plug
into outlet
The louver will automatically
move and close.
May cause deformation or safety
device activation.
If there is a noise in TV/radio or
radio clock does not display the
correct time, move the product
away as far as possible.
Thick carpet or futon is a very
unstable place.
Upper 50cm
or more
Behind 20cm
or more
Front 50cm
or more
Sides 20cm
or more
Operate it in a room with
temperature from 3°C to 38°C.
The compressor will stop and will not
dehumidify when the room temperature is
lower than 3°C or higher than 38°C.
(Switch to air flow mode)
The compressor safety
device will activate and stop.
Room temp. of
approx. 3°C-38°C
To prevent the water in the
tank from freezing, the
compressor will stop the
operation.
With a lot of salt such as seaside area.
With a lot of sulfide gas such as
hot-spring area.
With a lot of machine oil.
With a lot of steam or oily
smokes.
Do not use any cosmetic products formulated with fluororesin or
silicone near the dehumidifier.
Plasmacluster ion may not generate if fluororesin or silicone gets into
the main unit.
Hair care products (hair coating solution, hair mousse, hair treatment),
cosmetic products, antiperspirant, antistatic products, waterproof spray,
waxing products, glass cleaner, chemical cloth, wax, etc.
11
BEFORE USE
WHAT YOU NEED TO KNOW
When moving
Knob (both sides)
Defrosting
Auto Off function
After 12 hours
[Otherwise, the surface of floor or carpet may be damaged.]
CAUTION
1
2
Operation stopped
Press both for 3 seconds
Caster
Beep
To cancel the Auto Off function (For continuous drainage)
Lift up the main unit and move on easily scratched
floors like tatami, rough places and thick carpets.
Stop the operation
and dispose water
in the tank
Bundle the power cord and hold
along with the knob to move.
Pulling on the power cord will
damage the cord.
Hold the knob
to move
When the room temperature falls below 15°C, the unit will automatically start defrosting in order to prevent frost
from forming inside the main unit.
Once every 45 minutes, the compressor will stop and “HIGH” air flow mode will operate (for about 12 minutes).
The lower the room temperature, the longer the compressor stop time.
The compressor will stop and will not dehumidify during defrost, and water will not be collected in the tank.
The operation will stop automatically
after 12 hours in case the unit has
been forgotten to be turned off.
(The OFF TIMER “6h” indicator
light blinks)
Start
operating
Stop
operating
To operate again, press the STOP button to
release the blinking indicator light.
The Auto Off function is set when the power plug is plugged in.
Blinking
for 5
seconds
The Auto Off timer will turn off
when you press and hold both the
OFF TIMER button and STOP
button for 3 seconds.
Once the power plug is pulled, the
Auto Off function will be set again.
Press and hold both OFF TIMER
button and STOP button for 3
seconds to restart the Auto off
function.
It will take about 3 minutes to start
dehumidifying again for re-operation.
In order to protect the unit, the compressor will not operate for 3
minutes immediately after plugging in the power plug or stopping
(QUICK/ECO/CONTINUOUS) laundry drying/dehumidifying opera-
tion. Air flow mode will operate and the unit will not dehumidify.
Air flow operation for
about 3 minutes
FULL
220V power
supply

Related product manuals