E - 24 E - 25
3
WATER TANK
Once a week
REAR PANEL
Once every two weeks
1
2
4
Tank lid
Tank lid
1
Check float
FOR HEAVY DUST / WHEN ODOR IS A CONCERN
●
Do not wash with water
to wipe
3
2
1
WHEN NOT USING FOR A LONG PERIOD OF TIME
Plastic bag
(Back of main unit (inside))
Sensor
(odor sensor)
SENSOR
Soaking time: about 10 minutes
Rear panel
CARE AND
MAINTENANCE (Continued)
Remove the
dust with a
vacuum
cleaner
Dispose
water and
take the tank
lid off
Wash the
inside of the
tank
Dry the tank
with a soft cloth
Put the tank
lid on
●
For heavy dust
●
Do not apply too much force on
the filter.
(Otherwise, the filter may be
damaged.)
●
Wash the tank with dishwashing
sponge.
●
Use mild detergent (dishwashing
soap) with lukewarm water if
necessary.
●
Check to see if the float is
securely attached.
●
If the float comes off:
●
Take care not to damage the float.
●
Be sure to tightly close the tank
lid. (Otherwise, water may leak.)
●
Remove the lid slowly from the corner.
●
For heavy dust, soak a soft cloth in lukewarm
water (40°C or lower) or mild detergent to wipe
dirt off.
●
Clean the casters, too.
1 Soak and wash with
synthetic kitchen
detergent.
2 Gently scrub with a
toothbrush and fully wash so that there
would not be detergent residual left.
3 Dry in the shade.
1 Remove the rear panel and the filters.
2 Remove dirt on the sensor as shown in
the figure above with a cleaner.
3 Install the rear panel back to the product.
Store in a dry place with
no direct sunlight
CARE AND MAINTENANCE
We recommend periodical cleaning for
a long, clean and sanitary use! Diligent
maintenance is also necessary for
releasing of steady and high
concentration Plasmacluster ions.
[Otherwise, electric shock or injury may be caused]
WARNING
Always turn the operation “OFF” and unplug
the power plug.
E - 25
E - 30
Conduct internal
drying operation
Dispose tank water and clean
the main unit
Vacuum
cleaner
E - 22~25
Beep
E - 22
To Next Page
Loading...
