Sharp EL-1611P User Manual

11
RESETTING THE UNIT
Strong impacts, exposure to electrical fields, or other unusual
conditions may render the unit inoperative, and pressing the
keys will have no effect. If this occurs, you will have to press the
RESET switch on the bottom of the unit. The RESET switch
should be pressed only when:
• an abnormal event occurs and all keys are disabled.
• you install or replace the batteries.
Notes:
• Pressing the RESET switch will clear the stored tax rate and
other data stored in the memory.
• Use only a ballpoint pen to press the RESET switch. Do not
use anything breakable or anything with a sharp tip, such as
a needle.
• After pressing the RESET switch, press
฀
to make sure
that “0.” is indicated.
PRINTING SECTION
Printing speed: Approx. 1.4 lines/sec. (Printing speed
changes slightly depending upon the
printing digits per line.)
Printing paper: 57 mm (2-1/4") – 58 mm (2-9/32") wide
80 mm (3-5/32") in diameter (max.)
Operating temperature: 0°C – 40°C (32°F – 104°F)
Power consumption: 6V
(DC): 1.7 W
Dimensions: 96 (W) × 191 (D) × 40 (H) mm
3-25/32" (W) × 7-17/32" (D) × 1-9/16" (H)
Weight: Approx. 315 g (0.69 lb.) (with batteries)
Accessories: Ink roller × 1 (installed), Paper roll × 1,
Dry battery (R6)
× 4 and Operation
manual
Downloaded from: http://www.usersmanualguide.com/

Sharp EL-1611P Specifications

General

Type	Printing
Form factor	Desktop
Digits	12 digits
Battery type	AA
Number of batteries supported	4
Roll width	58 mm

Weight and Dimensions

Weight	315 g
Dimensions (WxDxH)	96 x 40 x 191 mm