Sharp EL-1750PIII User Manual

4
OFF • P P•IC
ON
POWER SWITCH; PRINT / ITEM
COUNT MODE SELECTOR:
“OFF”: Power OFF
“•”: Power ON. Set to the non print mode.
“P”: Power ON. Set to the print mode.
“P•IC”: Power ON. Set to the print and item count
mode.
1) For addition or subtraction, each time
is pressed, 1 is added to the item
counter, and each time
is pressed, 1
is subtracted.
• The count is printed when the calcu-
lated result is obtained.
• Pressing of
, clears the
counter.
2) When the grand total/rate setting mode
selector is in the ON position (GT), the
counter will count the number of times
that the calculation results have been
stored in the grand total memory. To print
and clear the count, press the
key.
3) The memory item counter will count the
number of times that the
key has
been pressed in the addition.
OPERATING CONTROLS
Note: • Each time the key is used in
the subtraction, 1 will be subtracted
from the count.
• The count is printed when the
memory is recalled.
• Pressing of the
key clears the
counter.
Note: The counter has a maximum capacity of 3
digits (up to ±999). If the count exceeds the
maximum, the counter will recount from zero.
ROUNDING SELECTOR:
Example: Set Decimal Selector to 2.
4
÷ 9 = 0.444 ... , 5 ÷ 9 = 0.555 ...
Note: The decimal point floats during successive
calculation by the use of
or .
If the decimal selector is set to “F” then the answer is
always rounded down (
).
4
9 5 9
0.45 0.56
5/4 0.44 0.56
0.44 0.55
EL-1750PIII(LCO)-Eng 04.9.15, 3:27 PM4

Sharp EL-1750PIII Specifications

General

Type	Printing
Form factor	Desktop
Digits	12 digits
Battery type	AA
Power source	Battery

Weight and Dimensions

Weight	500 g
Dimensions (WxDxH)	150 x 230 x 51.5 mm