Sharp EL-9400 - Calculator-to-Calculator Communication; Communication Procedure Setup; Receiver and Sender Modes; List of Sendable Data

EL-9400 Graphing Calculator
15
CE-450L
Communication cable
EL-9400 EL-9400
*
mark desired data to be
sent.
]
]
S et to set communication
Transfer data between two EL-9400 calculators using the communication cable (CE-450L).
5
7
8
9
Sender
Communication Procedure
( or )
A SELECT ....................... Sends files individually as described below.
1 ALL .............................. Selects and displays all files.
2 List ............................... Selects and displays all list files.
3 GraphEq ....................... Selects and displays all graph eqations.
4 Program ....................... Selects and displays all program files.
5 G_Data ......................... Selects and displays all graph data files.
6 L_Data ......................... Selects and displays all list data files.
7 Picture ......................... Selects and displays all picture data files.
8 A~Z, Ø .......................... Selects and displays all fixed memory of A to Z, and Ø
B BACKUP ...................... Menu to send all data of files. Use this
feature to send the entire content.
List of the SEND menu
Receiver
3
4
( or )
6
2
1
Plug the cable into both calculators.
Turn power on.
Specified LINK.
Select LINK/SEND.
Select SEND/ALL.
( or
2
)
( or
1
)
Select ‘LI’, ‘YI’
Execute Sending function.
Select LINK/RECEIVE.
Specified LINK.
List of sendable data will
appear on screen.
]
]