Sharp ES-FDD9144A0-EN - Pausing and Cancelling Programmes

Placing laundry into the machine
Ii\. You must select a programme before loading
~aundry into the machine. If you load laundry
into the machine without selecting a programme,
the load sensor will not be activated.
Note: The maximum load capacity of your machine may chan-
ge according to the programme you select. Do not exceed the
maximum dry loading capacity indicated in the programme table
for washing programmes. If YOU exceed the load capacity of the
programme you selected, i symbol will be displayed on the
screen of your machine and your machine will warn you with so-
und. It is advised that you remove laundry from your machine
until this symbol disappears. ~,
'c·· ... r::!!
a {)..,,--..~
\ -a--
b
..-;.,,,,.,,.. !>.J
i
'.l .~
\i ". ",.",~", .
...... ""-"
• Open the loading door of
your machine.
• Check inside the drum of
your machine. There might be laundry
left inside from previous washes. If
there is, empty your machine before
selecting your programme.
• Place your laundry into the machine by
spreading them well. Fold objects like quilts and blankets that
you will toad into the machine as shown below.
-.
Pausing a programme I Adding laundry
• You can pause or restart the programme you have selected with
theAbutton. You can use this function when you want to add
lau¥y to your machine.
30° 600
paused
• Washing
stopped.
II
1:24
l (2l III (10 ~l l'
1 I I I 1
• If [Q].r symbol is displayed on the screen, you can
open the door of your machine and add laundry.
• If IQ] i symbol is displayed on the screen you machine has
passed the laundry adding step.
Cancelling a programme
If you want to cancel a programme that is running:
- Switch the programme button to the the CANCEL position.
- Your machine will stop the washing operation and the program-
me will be cancelled.
- To get rid of the water accumulated in the machine switch the
programme button to any programme.
- Your machine will perform the necessary discharge operation
and cancel the programme.
- You can run your machine by selecting a new programme.