Unplug
the
machine.
Pump is damaged, pump
filter is clogged or pump electrical
connection is malfunctioning.
Clean the pump(**)filter.
If
the problem persists, contact the nearest
authorised service company.
A
FILTER
Check filter.
Pump
IS
damaged or pump
filter is clogged
or
pump electrical
connection is malfunctioning.
- Pump filter may be clogged.
- Clean
the
pump
filter.
("*)
- Drain hose may be clogged or twisted.
- Check
the
Drain hose.
- If
the
problem persists, contact the
nearest authorised service company.
• You should not load your machine with the amo-
unt of laundry that will exceed the maximum laundry
amount specified in the washing or drying program
you have chosen.
• In case of any malfunction, unplug the machine
and close the tap first. Do not attempt to repair by
yourself and consult the nearest authorized service
company.
• Never open the detergent compartment when the
appliance is running.
• Never force the door open when the machine is
running.
• Please adhere to the manufacturers' advice regar-
ding the use of fabric conditioner or similar products
you will use in your machine.
• While your machine is in the drying process, ple-
ase do not stop your mach ine before the program
ends.
If you have to do this, remove all your laundry fast
and spread them on an appropriate place immedia-
tely to allow them to cool down.
• Set up your machine in a place where its door can
be completely opened. (Do not set up your machine
in places where its door cannot be fully opened.)
• Set up your machine in locations that can be venti-
lated and might have constant air circulation.
To Next Page
Loading...