EN - 12
4. Insert the plastic blanking caps from the
accessories bag into the gaps left by the
transit screws.
4.2. Placing the Machine
and Adjusting the Feet
1
1. Do not install your machine on a carpet
or surface that will block ventilation at
the base.
2. To ensure silent and vibration-free
operation of your machine, install it on a
firm surface.
2
3. You can adjust the level of your machine
by using the gauge at the top.
3
4. You can level your Washer Dryer by
using the adjustable feet:
• Loosen the plastic adjustment nut.
• Turn the feet clockwise to increase the
height of the machine. Turn the feet anti-
clockwise to decrease the height of the
machine.
• Once the machine is level, tighten the
plastic adjustment nut.
• Never insert cardboard, wood or other
similar materials under the machine to
level it.
• When cleaning the ground on which
the machine is located, take care not to
disturb the level of the machine.
4.3. Electrical Connection
• Your Washer Dryer requires a 220-
240V, 50Hz mains supply.
• The mains cord of your machine is fitted
with a grounded plug.
• The plug should always be inserted to
a grounded socket of 10 amperes. The
fuse rating of the plug should also be 10
amperes.
• If you do not have a suitable socket and
fuse conforming with this, please ensure
the work is carried out by a qualified
electrician.
• We do not take responsibility for
damage that occurs due to the use of
ungrounded equipment.
NOTE: Operating your machine with
low voltage will cause the life cycle of your
machine to be reduced and its performance
52241755_D4_EN_new_reg.indd 12 24.05.2018 09:07:11
To Next Page
Loading...