Sharp ES-HFB8143W3-DE - Water Inlet Hose Installation

EN -29-
•Yourmachinemayhaveeitherasingleinlet
(cold)ordoublewaterinlets(cold/hot)basedonits
specications.
White-capped hose should be connected to cold
water inlet and red-capped hose to hot water inlet
(applicableformachineswithdoublewaterinlets).
•Toeliminatewaterleakagesinpointsofcontact,
1or2nutsareprovidedinthehosepackage(ap-
plicableformachineswithdoublewaterinlets).
Fitthesenutstotheendsofnewwaterinlethoses
onthesideoffaucet.
•Mountnewwaterinlethosestoa¾˝,threaded
faucet.
• Connect the white-elbow end of the water inlet
hosestothewhite-lteredwaterinletvalveonthe
rearsideofthemachineandthered-elbowendto
red-lteredone(applicableformachineswithdou-
blewaterinlets).
Tightenplasticpartsofthejunctionsusingyour
hand.
Inuncertainconditions,havetheconnectionworks
bedonebyaqualiedplumber.
•Flowofwaterwithpressureof0,1-1Mpawill
allowyourmachinetooperatemoreefciently.)
(0,1Mpapressuremeansthatmorethan8litres
ofwaterwillowthroughafully-tappedfaucetper
oneminute.)
•Ensurethatpointsofcontactdonotleakbytap-
pingthefaucetcompletelyaftercarryingmaking
theconnections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10mm