E-14
2012 March 7
HT-SL72 / HT-SL77 ZB271
Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the following
before calling your authorized SHARP dealer or service
center.
* For HT-SL77
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet. Condensation can cause the unit to
malfunction. If this happens, leave the power on until
normal playback is possible (about 1 hour).
When this product is subject to strong external interference
(mechanical shock, excessive static electricity, abnormal
supply voltage due to lightning, etc.) or if it is operated
incorrectly, it may malfunction.
If the unit is not restored in the previous operation,
unplug and plug in the unit again
or
unplug all component connected and plug in again.
During the Amplifier power on position (BLUE indicator
light up), press the PAIRING button for more than 10
seconds.
Note:
This operation will restore the DIGITAL (HDMI) function
volume to the default setting.
Periodically wipe the cabinet with a soft cloth.
Caution:
● Do not use chemicals for cleaning (gasoline, paint
thinner, etc.). It may damage the cabinet finish.
● Do not apply oil to the inside of each component. It may
cause malfunctions.
Symptom Possible cause
● No sound is heard
from Sound Bar/
Subwoofer.
● Is the TV input signal
(selection) set properly?
● Is HDMI compliant
equipment being used?*
● Is the HDMI cable
connected correctly?*
● Is the HDMI cable of the
correct type being used?
(with ARC)*
● Does the sound input
support PCM signal?*
● Do not connect or
disconnect an HDMI cable
while power is on. This
may lead to operation
problems.*
● Check if the Subwoofer
already turn on.
● Manually re-link the
Amplifier and Subwoofer
(refer page 13).
● Noise is heard
during playback.
● Move the speaker away
from any computers or
mobile phones.
● The power is not
turned on.
● Is the unit unplugged?
● The protection circuit may
be activated. Unplug and
plug in the power cord
again after 5 minutes or
more.
● Volume cannot be
controlled via TV.*
● Check if the HDMI CEC is
enabled.
● 3D images not
displayed on the TV.*
● Depending on the TV and
Video component, 3D
images may not be
displayed.
Check the operation
manual of the respective
component.
● Background noise
appears when
connecting with
headphone output of
TV-Terminal.
● Please change to HDMI/
ARC or RCA-Output
terminal from TV-Set. This
effect may occur
depending on TV-Brand,
model and age, and it is
not the Sound Bar
problem.
Symptom Possible cause
● Wireless connection
cannot be
established.
● Check the distance
between the Amplifier and
Subwoofer (less than 32
feet (10m)).
● Make sure there is no other
wireless devices near the
unit.
● Make sure there is no
obstacles (especially
metal) blocking between
the Amplifier and
Subwoofer.
● Manually re-link the
Amplifier and Subwoofer
(refer page 13).
● If the Amplifier is wall
mounted behind the TV,
make sure the distance
between the TV and
Amplifier are not less than
8" (20cm) to avoid wireless
interruption.
If problem occurs during operation
To Next Page
Loading...