EasyManua.ls Logo

Sharp KA-62V19IM0-EU - Page 64

Sharp KA-62V19IM0-EU
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
CHOOSING A PLACE FOR THE
OVEN
There are several points to pay atten-
tion to when choosing a place for your
oven.
Make sure to take into account our re-
commendations below in order to pre-
vent any problems and dangerous situ-
ations, which might occur later! When
choosing a place for the oven, attention
should be paid that there are no am-
mable or combustible materials in the
close vicinity, such as curtains, oil, cloth
etc. which quickly catch re.
Furnitures surrounding the oven must
be made of materials resistant to heat
more than 50 C° of the room tempera-
ture.
Required changes to wall cabinets and
exhaust fans above the built-in combi-
ned product as well as minimum he-
ights from the oven board are shown in
Figure 1. Accordingly, the exhaust fan
should be at a minimum height of 65 cm
from the hob board. If there is no ex-
haust fan the height should not be less
than 70 cm.
Figure 1
INSTALLATION OF BUILT-IN
OVEN
41mm
590mm
520mm
595mm
595mm
576mm
550mm
575mm
557mm
Min.
25mm
min. 150mm
min. 60 mm
560mm
490mm
min. 600mm
min. 555mm
max. 580m
min. 560mm
m
min. 590mm
2 x
Insert the oven into the cabinet by pus-
hing it forward. Open the oven door and
insert 2 screws in the holes located on
the oven frame. When the product fra-
me touches the wooden surface of ca-
binet, tighten the screws.
Worktop
min.
25 mm
min.
50 mm
Built-in hob
Built-in oven
If the oven is installed under a hob, the
distance between the worktop and the
top panel of the oven must be a mini-
mum of 50 mm and the distance bet-
ween the worktop and the top of control

Related product manuals