EN
4.2. HOW TO USE THE VISIO TOUCH CONTROL UNIT
M
Timer Setting/Temparature
settings for meat probe / Key
lock
Alarm Key Oven Function
Temparature Display Time Setting Key
Mode Key
Timer Display
Adjusting the Day Time:
When the built in oven installed rstly the
time of day must be adjusted according
to below instructions.
When oven installed rstly,“0.00” will start
to ash on the display. Touch “M“ sensor
or “ - “ and “ + “ sensors to adjust the day
time mode. “ : ” symbol will start to ash
on the display. You can adjust it with “ - “
and “ + “ sensor.If Auto cooking mode is
off, touch “ - “ and “ + “ sensors at the
same time to the day time mode. You can
adjust it with “ - “ and “ + “ sensor.
You have to adjust the day time to use
oven function.
ADJUSTING THE COOKER
TIME:
Adjusting the Minute Minder:
Touch alarm sensor which shows “ ”
symbol. “ ” will be ashing on the display.
“0.00” will appear on the clock digits. Adjust
the desired time period for the warning by
using Timer Plus and Minus sensor while
the symbol is ashing. Some time after
the completion of the adjustment, symbol
will begin to light continuously. When the
symbol begins to light continuously, the
audible warning time adjustment is done.
When the set time is up, the timer gives
an audible warning and symbol begins
to ash on the screen. Pressing “ - “or
“+“ will stop the audible warning and the
symbol disappears on the screen.
To Next Page
Loading...
