Sharp KB-6002L

10
BEFORE OPERATING
Before operating your new Microwave Drawer make sure you
read and understand this operation manual completely.
• Before the Microwave Drawer can be used, follow these
steps:
1 Plug in the Microwave Drawer.
ENJOY YOUR MICRO-
WAVE TOUCH CLEAR AND TOUCH CLOCK
will
appear.
2 Touch the Stop/Clear pad.
:
will appear.
3 Set clock.
TO SET THE CLOCK
1 Touch Timer/Clock pad and number 2.
2 Touch number pads for correct time of day and touch
Timer/Clock pad again.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time,
ERROR
will appear in the display. Touch the
Stop/Clear pad and re-enter the time.
• If the electrical power supply to your Microwave Drawer
should be interrupted, the display will intermittently show
ENJOY YOUR MICRO- WAVE TOUCH CLEAR
AND TOUCH CLOCK
after the power is reinstated. If
this occurs during cooking, the program will be erased. The
time of day will also be erased. Simply touch Stop/Clear
pad and reset the clock for the correct time of day.
Note:
• The Microwave Drawer can be programmed with the
drawer open except for START/Minute Plus.
TIMER
1 Touch Timer/Clock pad and number 1.
2 Enter time.
3 Touch Timer/Clock pad again.
To cancel timer, touch Stop/Clear.
STOP/CLEAR
Touch the Stop/Clear pad to:
1 Erase if you make a mistake during programming.
2 Cancel timer.
3 Stop the Microwave Drawer temporarily during timed
cooking.
4 Return the time of day to the display.
5 Cancel a program during cooking, touch twice for timed
cooking.
OPEN OR CLOSE MICROWAVE DRAWER
(For models KB-6015K & KB-6014L)
Always press the OPEN or CLOSE pad on the control panel
to open or close the Microwave Drawer.
Do not push or pull the Microwave Drawer by hand,
except in case of emergency, such as a power failure. If
necessary, push or pull slowly.
(For model KB-6002L)
Open and close the Microwave Drawer by gently pulling and
pushing with even pressure near the middle of the drawer
handle.