Sharp KP-19S - Troubleshooting Guide

TROUBLESHOOTING GUIDE
12
Poor installation of inner lid. Set correctly.
Defective packing. Replace.
Loosened inner lid packing. Secure correctly.
Defective inner lid packing. Replace.
Incorrect attachment of inner lid Set correctly.
packing.
Bellows assembly. Air leak from the bellows. Replace.
Dislocation of bellows cap Set correctly.
packing-B
Problem Check point Possible cause Correction action
No power is supplied. Plug of Power cord Not inserted into outlet. Insert it into outlet.
(“BOIL” indicator lamp dose ass’y.
not light up.) Connector of Power cord Disconnected from inlet Connect with inlet.
ass’y . terminal.
Power cord ass’y. Disconnection. Replace.
Blown out Replace and explain
(by repeated heating without the users not to heat
water). the pot without water.
Blown out Replace.
(by deformation of heater).
Disconnection. Replace.
Internal wiring. Erroneous wiring. Correct wiring.
Terminal screw. Loosened or missing. Retighten.
(Inlet terminal)
Thermostat. Poor operation Replace.
(no conduction).
“BOIL” indicator lamp lights up Heater set assembly. Disconnection. Replace.
but water is not heated.
Boiling continues. Thermostat. Poor operation. Replace.
Internal wiring. Erroneous wiring. Correct wiring.
Outer lid ass’y. Not secured on the body. Secured on the body.
Water temperature is kept Heater set assembly. Disconnection in heating Replace.
low. circuit.
Internal wiring. Erroneous wiring. Correct wiring.
Thermostat. Poor operation. Replace.
Hot water is not or hardly Water temperature. Water is tepid or cold. Explain users that pouring
poured from spout. amount is very small for
tepid or cold water.
Push button. Pushing with undue force. Instruct the users to push
with a proper force.
Pushing the outer edge of Instruct the users to push
the button. at the center of the button.
Inner lid. No inner lid. Attach inner lid.
Temperature fuse.
Indication lamp
assembly.