1. For power supply use the proper socket.
1.1 Do not connect too many loads to one outlet.
1.2 If any of the power supply cord, plug and connector is damaged or feel abnormally hot. Immediately
call the serviceperson to repair it. Otherwise, this will cause an electric shock or fi re.
2. Do not immerse the unit in water or splash it with water.
This will result in malfunctioning or electric shock.
3. Do not operate the unit without water in the pot.
This will cause malfunctioning or discolouring of the inner pot.
4. Close lid fi rmly.
Otherwise hot water outfl ow so much when tumbling.
5. Do not put milk, liquor, tea, ice cubes and etc. in the pot.
This will result in malfunctioning or electric shock.
6. The power cord ass’y (supplied) is only for the product. Do not use it for other apparatus or apply
the other type of power cord ass’y to this product.
7. When put water into the pot :
7.1 Be sure to keep the water level between the “Refi ll” level and “Full” level.
7.2 If water is put above the “Full” level, the hot water may be overfl ow from the spout during boiling.
7.3 Do not put water into the pot directly from the tap, because fl ooded water may intrude into the
mechanism and cause an electric shock and malfunctioning.
8. Location
8.1 Do not use or place the unit on an unstable, wet fl oor or adjacent to other heat generating apparatus,
as this will cause the unit to fall down, deform itself or malfunction.
8.2 Keep the pot away from child not to cause an accidental scald or injury.
9. When plugging the power cord ass’y :
Remove iron chip and dust from the connector plug and inner terminal.
10. When boiling and warming water :
10.1 In the beginning of operation, the unit may generate plastic smell or oily smell of the heater, but this
will hardly occur as the usage lasts.
10.2 Sounds are emitted during the boiling and warming. But this is quite normal.
10.3 Keep the power cord ass’y plugged during the warming, otherwise the water temperature goes
down gradually.
10.4 Sometimes exchange the water in the pot not to degrade water quality.
10.5 Disinfectant contained in tap water or some water may cause a smell when it is heated.
10.6 Pressing the push button with undue force may cause the hot water to scatter so as to result in scald
or injury.
10.7 If the water level in the pot go down below the “Refi ll” level during operation, be sure to add water.
Otherwise the unit may be damaged.
10.8 The inner lid becomes heated during operation; use a dish cloth or the like when removing it.
10.9 Do not carry the pot at the condition of inclining.
CAUTIONS FOR USE
3
To Next Page
Loading...
