LC-19LE320, LC-22LE320, LC-26LE320, LC-32LE320, LC-37LE320, LC-42LE320
130
Supports Dolby Digital AC-3 decoding (ATSC), E-AC-3 decoding
MPEG-1 layer I/II decoding
Dolby Prologic II
Supports WMA / HE-AAC / ADPCM / LPCM / MP3
Audio output: 5.1ch + 2ch (down mix) + 2ch(bypass) + 2ch(TV bypass)
Pink noise and white noise generator
Equalizer
Bass management
3D surround processing with virtual surround
Audio and video lip synchronization
Automatic volume control
Supports 5-bit (10-channel) main audio I
2
S output interface: each of these channels is up to 24-bit resolution.
S/PDIF interface
One SPDIF input
One SPDIF out
Digital TV(DVB-T) Demodulator
COFDM (Coded Orthogonal Frequency Division Multiplex) channel demodulator for DVB-T receiver
ETSI 300 744 & Nordig Unified compliant
Excellent performance for SFN (Single Frequency Network) & Indoor reception
Supports 2K, 8K modes
Supports QPSK,16,64 QAM constellations
1/4,1/8,1/16,1/32 Guard interval
Supports hierarchical & non-hierarchical modes
Accept 6,7,8 MHz channel bandwidth
Automatic mode detection
Full-digital timing/frequency with wide acquisition range
Supports triple offset
Excellent adjacent Channel interference (ACI) rejection capability
Excellent Co-Channel interference (CCI) rejection capability
Fast channel lock time
Analog TV IF Demodulator
Supports PAL/SECAM standard
Supports B/G, DK, I, L, L’, M/N standard
Accept IF frequency at 38.25 MHz
Full digital AGC control and carrier recovery
Peripherals
Three built-in UARTs with Tx and Rx FIFO. Two of them have high speed data transferring.
The MT5363LICG family has two basic serial interfaces; one is for the tuner or the master for general purpose, the other is the slave for HDMI
EDID data.
Three PWMs
MT5363LICG supports MS/MS-PRO, SD/MMC, and SDHC card reader.
IR receiver
Real-time clock and watchdog controller
The MT5363LICG includes 1-link USB2.0/1.1 (supports external hub) for USB mass storage class device.
Built-in uP in standby module
SDIO interface (for DSG, WiFi or UWB)
Supports two serial flash or one serial and one NAND
Supports six-input low-speed ADC.
Supports boundary scan (JTAG)
Supports MII interface (built-in Ethernet MAC)
IC Outline
To Next Page
Loading...
