3
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Confi rm the screws supplied with the TV.
Screw driver
Screw
Soft cushion
Screws (
m
4)
(used in step 3)
2
Insert the stand base to the stand post on the
bottom of the TV. (
1
)
3
Insert and tighten the 4 screws into the 4 holes
on the bottom of the stand base. (
2
)
NOTE
• To detach the stand, perform the steps in reverse order.
15°
15°
CAUTION
• Adjust the screen with both hands. Put one hand on
the TV and rotate the screen while steadying the stand
with your other hand.
The TV can be rotated up to 15 degrees to the right or left.
Setting the TV
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
A
C
IN
P
U
T
AC IN
PU
T
To AC INPUT
terminal
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
Room antenna terminal
(75-ohm type)
Antenna cable
(commercially available)
To antenna
terminal
Connecting the AC cord
(Only for LC-40L550X/
LC40L650X)
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
• The illustrations used throughout this manual are based on LC-40L550X.
LC32L450X_EN.indb 3LC32L450X_EN.indb 3 05/08/10 02:54:22 PM05/08/10 02:54:22 PM
To Next Page
Loading...
Need help?
General