• Automatically-calculated constant-rate TS output (using L1 signalling and ISSY)
• Frequency offset detection range up to +/-600 kHz allows acquisition and performance optimization via tuner frequency
offset compensation
• Stream processor for automatic common-PLP and data-PLP combination
• Null-packet insertion
• Improved performance for multipath channel (outside the guard interval)
Features DVB-T
• Complies with all European standards for static and portable equipment including NorDig-Unified Test Specification
ver2.2.1 DTG D-BOOK 7.0 V2.0, IEC 62216 and targeting upcoming Digital Europe Ebook requirements
• Smart Auto Acquisition controller with fast 2k/8k acquisition, low processor overhead and re-acquisition mode
• Frequency offset detection range up to +/-600 kHz allows acquisition and performance optimization via tuner
frequency offset compensation
• Advanced channel corrector for low multipath loss and enhanced Doppler performance
• Improved CNR performance
Features DVB-C
• Complies with NorDig-Unified Test specification Ver2.2.1
• Wide symbol range, 1.8 to 7.2 Msym/s
• Integrated matched filter 0.15 roll-off factor
• Frequency offset detection range up to ±500 kHz allows acquisition and performance optimization via tuner frequency
offset compensation
• Excellent equalization for cancellation of reflections at larger delays
• Improved performance against large continuous wave interference
• General Features
• Single, 41 MHz or 20.5 MHz crystal with tolerance up to ±100 ppm. (Targeting support for crystal sharing with Sony
SiTuner or other Sony Analogue/Digital demodulator)
• High performance ADC
• RF power level monitor ADC
• Low IF and high IF (36 MHz) mode input
• Fast 400 kHz I2C compatible bus interface
• Quiet I2C interface for dedicated tuner control
• Programmable I2C addresses allowing up to four devices to be connected in a single system
• Automatic IF AGC and optional programmable RF AGC/GPIO functions
• Configurable parallel and serial MPEG-2 TS outputs with smoothing buffer
• Simple API
• 3.3 V, 1.1 V supplies
• 48 pin VQFN 7 mm x 7 mm package
• Supplied with full reference design, including software driver, printed circuit board schematic/layouts and
documentation
Applications
• Set Top Boxes
• IDTV with Digital only or Hybrid Tuner Support
• PC TV
• PVRs and recordable Blu-rayTM/DVD players
• Professional equipment
7.3. U405 (TC58NVG0S3HTAI0 only for LC-50LD266)
General Description
The TC58NVG0S3HTAI0 is a single 3.3V 1Gbit (1,140,850,688bits) NAND Electrically Erasable and Programmable Read-Only
Memory (NAND E
2
PROM) organized as (2048 +128) bytes × 64 pages × 1024blocks. The device has a 2176-byte static
registers which allow program and read data to be transferred between the register and the memory cell array in 2176-byte
increments. The Erase operation is implemented in a single block unit (128 Kbytes + 8 Kbytes: 2176 bytes × 64 pages). The
TC58NVG0S3HTAI0 is a serial-type memory device which utilizes the I/O pins for both address and data input/output as well as
for command inputs. The Erase and Program operations are automatically executed making the device most suitable for
applications such as solid-state file storage, voice recording, image file memory for still cameras and other systems which
require high-density non-volatile memory data storage.
Features
‧Organization
x8
Memory cell array 2176 64K 8
To Next Page
Loading...
Need help?
General