79
• after upgrading nished.
Factory Setting Upgrading
Operation Procedure
After Unzip the upgrade package, put the Unzip le “allupgrade_6488.bin” into USB ash disk on
root directory, and then insert the USB ash into board.
Press <menu>+1147 to enter the factory menu setting, search for the “SW UPGRADE” item by
scrolling up and down, and then elect to enter the SW upgrade mode.
Once enter SW upgrade mode please check whether the upgrade le was exist and the le name
was correct, and then select upgrade TV start to upgrade software.
Upgrade Prompt
• Turn o TV
• Copy upgrade le to USB storage Root directory
• Insert USB storage to TV
• Turn on TV, if upgrade le is correct, TV will start upgrade automatically.
• When upgrading, the TV set will light panel according to the panel parameter, and display the
progress bar. If the panel parameter of board matches the panel, you will see the
• following image:
• After upgrade succeed, please put o USB storage
• Restart TV.
6.3.5 Serial Upgrading
Tools prepare
Earphone Serial Port board: B.CNSISP7A
USB extension cord
Serial port tool software
To Next Page
Loading...
Need help?
General