Sharp MD-MS701H - Page 27

MD-MS701H/MS702H
– 27 –
: Control setting menu
: Play start SD number, EEPROM version  : setting : REC superposition, EL existence/nonexistence, move start minimum number, high-speed jump over-run  : setting : DC-IN existence/nonexistence judgment level, AC adapter judgment level, built-in battery full judgment level  : setting : Recording bit distribution parameter 0  : setting : Recording bit distribution parameter 1  : setting
: Syncro level selection  : setting
: Dry cell exhaustion detection level setting 1  : setting : Dry cell exhaustion detection level setting 2  : setting : Built-in battery exhaustion detection level setting 1  : setting : Built-in battery exhaustion detection level setting 2  : setting : Intermittent servo restart accumulation sector number setting  : setting : Control setting 2  : setting : Control setting 3  : setting : Control setting 4  : setting : Control setting 5  : setting : Control setting 6  : setting
PLAY
C T R L
Control Setting (record/playback machine)
C T 0
C T 1
SKIP UP SKIP DOWN
P W L
SKIP UP SKIP DOWN
R C 0
SKIP UP SKIP DOWN
R C 1
SKIP UP SKIP DOWN
S Y C
SKIP UP SKIP DOWN
D R 1
SKIP UP SKIP DOWN
D R 2
SKIP UP SKIP DOWN
I N 1
SKIP UP SKIP DOWN
I N 2
SKIP UP SKIP DOWN
I N R
SKIP UP SKIP DOWN
C T 2
SKIP UP SKIP DOWN
C T 3
SKIP UP SKIP DOWN
C T 4
SKIP UP SKIP DOWN
C T 5
SKIP UP SKIP DOWN
C T 6
SKIP UP SKIP DOWN
Continued to the next page
SKIP UP SKIP DOWN
: Control setting 2  : setting : Special mode selection data (unprotect area)  : setting : Monitor selection data (unprotect area)  : setting : Control-related other setting data (unprotect area)  : setting
Continued from the preceding page
C T 7
SKIP UP SKIP DOWN
S P M
SKIP UP SKIP DOWN
M S L
R S L
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set. * In specific state pressing the [DISP] key causes change to "focus setting menu". * In the specific setting display state the setting change digit changes when the [P-MODE] key is pressed.  1st digit (initial value) 2nd digit
P-MODE
P-MODE
* In the specific state the setting changes in the range of "0h to Fh" when the [VOL UP/DOWN" key is pressed.