Sharp MD-MT15

To check the remaining disc time 1 Double time recording in monau-
While recording, you can check the remain-
ing time available on the disc.
Press the DISPLAY button while recording
(or while in the recording pause mode.
Femaining recordable ime,
© When the DISPLAY button is pressed
again, the unit will return to the initial cis-
play.
Note:
(© Tho display ofthe remaining disc time
‘may vary sight trom the actual remain-
ing time. (Page 38)
To create your own track numbers,
while recording
You can create your own track numbers at
special points ina recording, so that these
points can easily be found later
A any polo where you wat eae 0
k number while recording, press the
ee butlon
(© The track number will be written on the
{disc and the recording will continue un-
interrupted.
7
Tal mode
When recording in the monaural long-play
‘mode, you can record twice as long as the
‘recording time availabe fora stereo record
ing. The monaural long-play mode is very
Useful for recording conferences or lectures.
‘© Each ime this buttons pressed, the dis-
play will switch between the stereo mode
Notes:
@ If input is trom a stereo source. the
‘Sounds from the left and right channels
will be combined.
© Aithough the monitor sound you hear in.
the headphones while recording sin ste-
60, recording wil be monsura.
(© MiniDiscs recorded in the monaural
long-play mode may not play on other
MO players.
(© When a recording is made in the mon-
aural long-play mode, you will be able
to play back the MiniDisc twice as fast
{a the normal playback speed.
(Page 24)
‘© When the units stopped after a record-
inghas been made in the monaural long-
play mode, the recording mode will re-
turn to the stereo mode automaticaly.
‘To erase tracks one at a time:
1 sian piaying the track you wantto erase,
‘and press the Pit button.
{© The unit wil enter the pause mode.
2 Press the EDIT button to select
3 Press the ENTERISYNC button.
To cancel the operation, press the
OFF bution.
4 Press the ENTER/SYNC button again.
(© The track wil be erased.
3 4
Pe ign |
Orenis
NO_NAME
ERASE G3?
5 To erase other racks, repeat steps 1-4,
To erase all of the tracks at once:
1 wile in the stop mode, press the EDIT
button to select “ALL ERASE”.
{@ "ALL ERASE” can also be selected
‘by holding down the EDIT button for
atleast 2 seconds.
2 ress the ENTERISYNC button.
© 70 cancel the operation, press the
OFF bution,
3 Press the ENTER/SYNC button again.
‘© Allotthe track numbers, tracknames,
‘and disc names will be erased.
Sm 0
BLANK DISC
Notes:
© Once a track has been erased, it can-
‘not be recovered. Double-check the
track number before erasing it.
‘© When a track's erased, the numbers as-
‘signed tothe tracks following the erased
‘rack willbe automatically decreased by
‘one.
© When a track is erased, the track name
will be erased at the same time.
18