Sharp MD-MT80H - Error Messages

ENGLISH
00/12/27 E_80seeg_6.fm
E-39
References
-Error Messages-
Error Messages
ERROR
MESSAGES
MEANING REMEDY
BATT EMPTY
z The battery is run down. z Charge the rechargeable battery or replace the alkaline
battery (or use the AC adaptor for power).
BLANK MD
z Nothing is recorded. z Replace the disc with a recorded disc.
Can't COPY
z You tried to record from a copy prohibited MiniDisc. z Record using the analogue cable.
Can't EDIT z A track cannot be edited. z Change the stop position of the track and then edit it.
Can't READ (*)
z The disc data cannot be read because the disc or
unit is damaged.
z Reload the disc.
z Replace it with another recorded disc.
Can't REC z Recording cannot be performed correctly due to vi-
bration or shock.
z Re-record or replace it with another recordable disc.
Can't STAMP
z Stamp function does not work. z Check the number of tracks.
Can't WRITE
z Cannot save the TOC information correctly to a Mini-
Disc. (A large portion of the disc has been dam-
aged.)
z Replace the disc with another recordable disc.
DEFECT z The disc is scratched. z If the sound you hear is not right, record again.
z Replace the disc with another recordable disc.
DISC FULL z The disc is out of recording space. z Replace it with another recordable disc.
Er-MD (**) z The microprocessor has reported a system fault and
the unit is out of order.
z To have it repaired, go to the distributor where you pur-
chased the unit.
HOLD z The unit is in the hold mode. z Cancel the hold mode.
LOCKED z You removed a MiniDisc whilst recording or editing. z Turn off the power and remove the MiniDisc.
NO DISC z A disc has not been loaded. z Load a disc.