Sharp MD-R2

(Continued)
● The character will disappear.
● The original characters will move
to the right by one.
■ To erase a character
After performing steps 1 to 3 on page 29, do the following:
Example: To change “BESUT” to “BEST”
4 Press the 3 / 2 button to make the character you want to
erase begin flashing.
5 Press the DELETE/CLEAR button.
6 Press the NAME/TOC EDIT button.
■ To add a character
After performing steps 1 to 3 on page 29, do the following:
Example: To change “BST” to “BEST”
4 Press the 3 / 2 button to make the character at the place
you want to add a letter begin flashing.
5 Select the character you want to add, using the jog dial. Then,
press the ENTER button.
6 Press the NAME/TOC EDIT button.
■ To correct a spelling
After putting the unit in the character input mode, erase the wrong
character. Then, enter the correct character.
■ To erase disc names or track names
After performing steps 1 to 3 on page 29, do the following:
Press the DELETE/CLEAR button for at least 2 seconds, and
then press the ENTER button.
● The disc or track name will be erased.
NAME/TOC EDIT
DISPLAY/CHARACTER
DELETE/CLEAR
TIMER
ENTER
TOC DISC
6
(To add a character to left of the "S")
4
(To add the letter "E")
5
(To erase the letter "U")
4
5
TOC DISC
6
MD-R2
30