39
Fax
Has cut-off printing been disabled in
the setting mode (administrator)?
■ Load the same size of paper as the received fax.
If [Print Actual Size Cut off Disabled] is enabled in [Print Style Setting] in the
setting mode (administrator) and a fax is received that is larger than any paper
that is loaded, the fax will be received and stored in memory without being
printed. (However, when a fax longer than 11" x 17" (A3) size is received, it will
be printed using multiple sheets of paper.)
"Setting mode"
→
[System Settings]
→
[Image Send Settings]
→
[Fax Settings]
→
[Receive Settings]
→
[Print Style Setting]
Is forwarding (Inbound Routing
function) enabled for a received fax?
■ If you need to print a received fax, ask your administrator.
When the Inbound Routing function is enabled, received faxes are automatically
forwarded to a specified address. If [Print at Error] is selected when Inbound
Routing is enabled, received faxes will only be printed when an error occurs.
"Setting mode (administrator)"
→
[Image Send Settings]
→
[Inbound Routing (Forwarding/Storing) Settings]
→
[Administration Settings]
→
[Inbound Routing Settings]
MANUAL RECEPTION/POLLING RECEPTION
ARE NOT POSSIBLE
Check Solution
Is little free memory remaining? ■ If any of the following applies, print or delete received faxes to increase available
memory space for receiving faxes.
• The memory contains data that has been received with the received image
check setting enabled.
• The memory contains data that has been received with confidential reception
or that is protected by a password.
• A fax is stored in the memory box.
THE RECEIVED IMAGE IS FAINT
Check Solution
Is the original that was faxed also
faint?
■ Ask the other party to send the fax again using a suitable (darker) exposure
setting.
Check Solution
To Next Page
Loading...
