Sharp MX-5111N - Page 44

TEST SIMULATION
SHARP
44
44
Process Control Data
29
Enable/disable half tone correction during
each job
31
OPC drum position adjustment
37
DV bias correction level setting for
continuous print mode.
43
DV unit installation monitor
61
Colour image density sensor adjustment
62
Process control execution condition
setting
46
Copy & Image Density Adjustment
1
Colour copy density adjustment
2
B/W copy density adjustment
4
Colour scanner density adjustment
5
B/W scanner density adjustment
8
Colour scanner balance adjustment
9
SPF exposure adjustment
10
Engine colour balance manual adjustment
16
Engine balance manual adjustment B/W
19
B/W auto exposure mode setup
21
Engine colour balance adjustment (All)
23
Enable/disable maximum density adjust.
24
Engine half tone auto adjustment
25
Single colour mode colour balance set-up
26
Single colour mode colour balance adjust
27
Coefficient (Black edge) gamma set-up
30
Resolution adjust (sub-scan – copy mode)
32
Document background density adjust.
36
2-colour mode adjustment (Red, Black)
37
B/W image create adjustment
38
Black component adjustment (Copy mode)
39
Fax Image send sharpness adjustment
40
Fax mode exposure adjust (All modes)
41
Fax mode exposure adjust (Normal)
42
Fax mode exposure adjust (Fine Text)
43
Fax mode exposure adjust (Super Fine)
44
Fax mode exposure adjust (Ultra Fine)
45
Fax mode exposure adjustment (600dpi)
46
Fax mode exposure adjustment (RIP)
47
JPEG compression rate setting
51
Heavy paper mode gamma adjustment
52
Heavy paper mode gamma default set
54
Half tone density adjustment (dither).
55
Drop out colour mode adjustment for
Image Send mode.
58
Copy mode pseudo resolution setting
(smoothing process).
46
Copy & Image Density Adjustment
59
Copy mode pseudo resolution image
process adjustment.
60
Sharpness adjustment (colour auto mode)
61
Area separation recognition setting
62
ACS operating condition setting
63
Copy low density adjustment
65
Colour correction table setting.
66
Watermark adjustment for Copy/Printer
74
Copy colour balance adjustment
90
Set process operation of high compression
PDF images
91
Adjust reproduction of black text.
48
Magnification & Motor Adjustment
1
Magnification ratio adjustment
5
Motor speed adjustment (Scanner & SPF)
6
Motor velocity adjustment
49
Firmware & E-Manual Upgrade
1
Firmware Upgrade Program
3
E Manual Update Program
5
Watermark Update Program
50
Image Position Adjustment
1
Lead edge/copy position adjustment
2
Lead edge/copy position adjustment (Calc)
5
Printer lead edge adjustment (sub scan)
6
SPF Lead edge/copy position adjustment
7
SPF Lead edge/copy adjustment value
10
Print off-centre deviation adjustment.
12
Original centre deviation adjustment.
20
Manual colour registration adjust.
22
Auto colour registration & drum
adjustment
24
Auto registration & drum data display
27
Image loss adjustment (Fax/Scanner)
28
Service adjustment (OC/SPF position)
51
Resist Roller Adjustment
1
Transfer voltage ON timing adjustment
2
Resist roller adjustment
53
Document Feeder Adjustment
6
SPF document tray size adjustment
7
SPF document tray size adjust value set.
8
SPF scanning position adjustment