Sharp MX-5111N - Page 58

REPAIR HINTS
SHARP
58
TROUBLE INDICATIONS
All
Card Reader communication trouble.
This indication is displayed if a Card Reader is not
detected correctly when a Card Reader is registered on
the MFP.
Enter User Control – Card Type/ Card Reader Settings
menu and uncheck Use IC Card for Authentication
And/or de-register the Card Reader from Card Reader
Device Registration menu via the operation panel.
MX-EB12
HDD Trouble: Use SIM62-20 to check the HDD status.
For troubleshooting, refer to the MX-EB12 Mirroring Kit
section within this guide.
TROUBLE CODES
ALL
C4-20
Check if the Black drum cleaning blade has flipped.
Also check the condition of the primary transfer belt
unit.
E6-11 trouble after replacing the DSPF
Control PWB or DSPF CCD Unit.
DSPF Shading Adjustment (SIM63-2) must be executed
after replacing the DSPF CCD Unit, DSPF Control PWB
or following U2 trouble.
Use DSPF Shading Adjustment Sheet [UKOG-0333FCZZ],
MX-FX11
E7-07 error when sending or receiving
large volume of fax jobs
Upgrade the firmware to 04.00.R1 (or higher).
ALL
Intermittent E7-20
MX-EB11
E7-48
To support MX4111/5111N series and prevent E7-48
trouble, the MXEB11 firmware must be upgraded to
02.00.A1 (or higher).
ALL
E7-95
Check PCL Flash ROM , replace if required.
Also ensure to upgrade the Firmware to current version
MX-FNX9
F1-00 trouble after a firmware
upgrade
When performing a firmware upgrade on the Inner
Finisher, ensure to select both BOOT & MAIN firmware
after executing Sim 49-01.
Due to a recent change, both BOOT & MAIN firmware
versions have been upgraded however, if only the
MAIN firmware is selected and upgraded, F1-00 trouble
may be experienced when using the combination of
original BOOT and current MAIN firmware versions.
MX-FN10
F1-08
Upgrade the MXFN10 Firmware to v01.10.02 (or
higher) for improved Gripper control
Ensure "Super Lube" Synthetic Multi-Purpose Grease
(SUP21030) is applied to the square shaft within the
staple unit otherwise, the gripper drive gear (PG:
Section 24 item 11 - 0CW4158P418//) may wear
prematurely, causing it to bind under load.
ALL
U5-16 trouble (DSPF cooling fan
permanently runs)
Replace the DSPF Driver PWB (CPWBN1982FCE1).
ALL
Constant Error 1206 when adding an
address destination - even after
resetting system settings back to
factory default.
Check the HDD operation for bad or corrupted
partition. Execute Sim 62-01 and format the HDD.
If the problem persists after formatting, replace the
HDD unit.