Sharp MX-M316N

SHARP
TEST SIMULATION
39
66
Fax Control Settings & Adjustments
1
Fax Soft SW setting
SW27-5
V.34 mode function (polling
when calling):-
0 = V.34 valid.
1 = V.34 invalid.
SW27-6
V.34 mode function (manual
communication):-
0 = V.34 valid.
1 = V.34 invalid.
SW33-6,7
Transmission cable amplitude
equaliser:-
00 = 0dB
01 = 4dB
10 = 8dB
11 = 12dB
2
Country code default set (Fax)
3
Fax PWB controller memory check
4
Fax signal line check (Max level)
5
Fax signal line check (Soft SW setting
level)
6
Fax list print (confidential registration)
7
Fax memory printout (all data)
8
Fax sound message setup
9
Fax signal line check (Soft SW setting)
10
Fax all memory clear
11
Voice signal check (line/speaker 300bps)
12
Voice signal check (line/speaker 300bps)
13
Register dial number for Sim 66-14/15/16
14
Adjust/check the time dial pulse (10bps)
15
Adjust/check the time dial pulse (20bps)
16
Adjust/check the send level DTFM signal
17
DTFM signal to send to line (Max level)
18
DTFM signal to send to line (Soft Sw level)
21
Print various registration information
22
Set the sound volume of the handset
24
Fast memory data clear
29
Fax address book clear
30
Tel/LIU sensor status check
31
ON/OFF setting of output port (Tel/LIU)
32
Received data check (comparison)
33
Busy Tone/CNG/CED/FNET detect check
34
Display time required for sending test
data
36
Check Send/Receive from modem.
39
Check Destination saved in Fax EEPROM
42
Rewrite PIC program installed on Fax box
43
Write program & adjustment values to
PIC installed on Fax
61
Display FAX related soft switch (151-250)
62
FAX receive data export in PDF format.
67
Printer Settings & Adjustments
17
Printer NVRAM clear
45
Printer image filter and trapping
adjustment.